|
|
|
|
|
General |
VX-5500L |
VX-5500V |
VX-5500U |
||||||||||||
| LOW | VHF | UHF | |||||||||||||
|
Frequency Range |
29.7- 37 MHz
(A) 37- 50 MHz (B) |
134-160 MHz
(A) 148-174 MHz (C) |
400-430 MHz (A) 450-490 MHz (D) 480-512 MHz (F) |
||||||||||||
|
Number of Channels |
250 Channels |
||||||||||||||
|
Channel Spacing |
20 kHz | 12.5/25/30 kHz | |||||||||||||
|
PLL Steps |
5/6.25 kHz | 2.5/5/6.25 kHz | |||||||||||||
|
Power Supply Voltage |
13.6 VDC ±20% | ||||||||||||||
| Current Consumption |
|
||||||||||||||
| Operating Temperature Range |
-22° F to +140° F (-30° C to +60° C) |
||||||||||||||
| Frequency Stability |
Better than ±5 ppm |
Better than ±2.5 ppm |
|||||||||||||
| RF Input-Output Impedance |
50 Ω |
||||||||||||||
| Audio Output Impedance |
4 Ω |
||||||||||||||
| Dimensions |
7"(W) x 2.4"(H) x 7.7"(D) (178 x 60 x 195mm) |
||||||||||||||
| Weight |
4.9 lbs (2.2 kg) |
||||||||||||||
| Receiver |
Measurements made per EIA standard TIA/EIA-603 |
||||||||||||||
| Circuit Type | Double Conversion Super-heterodyne | ||||||||||||||
| Sensitivity (EIA 12 dB SINAD) |
0.25 uV |
||||||||||||||
| Adjacent Channel Selectivity |
85 dB |
85 dB / 77 dB | |||||||||||||
| Intermodulation |
80 dB |
80 dB / 75 dB |
|||||||||||||
| Spurious and Image Rejection |
90 dB |
90 dB |
|||||||||||||
| Audio Output |
5 W @ 4 Ohms 3% THD |
||||||||||||||
| Transmitter |
Measurement made per EIA standard TIA/EIA-603 |
||||||||||||||
| Power Output |
70 W/30 W |
50 W/5 W |
40 W/5 W |
||||||||||||
| Modulation |
16KOF3E |
16KOF3E, 11KOF3E | |||||||||||||
| Max Deviation |
5 KHz |
5.0 / 2.5 KHz | |||||||||||||
| Conducted Spurious Emissions |
80 dB Below Carrier |
||||||||||||||
| Audio Distortion (@ 1 kHz) |
< 2 % |
||||||||||||||
| Microphone type | Dynamic | ||||||||||||||
| Microphone impedance | 600 Ω | ||||||||||||||
|
APPLICABLE MIL-STD |
|
Standard |
MIL 810C Methods/Procedures |
MIL 810D Methods/Procedures |
MIL 810E Methods/Procedures |
|
Low Pressure High Temperature Low Temperature Temperature Shock Solar Radiation Rain* Humidity Salt Fog Dust Vibration Shock |
501.1/Procedure II 502.1/Procedure I 503.1/Procedure I 505.1/Procedure I 507.1/Procedure II 514.2/Procedure VIII, X 516.2/Procedure I, V |
500.2/Procedure II 501.2/Procedure I, II 502.2/Procedure I, II 503.2/Procedure I 505.2/Procedure I 506.2/Procedure I, II 507.2/Procedure II 509.2/Procedure I 510.2/Procedure I 514.3/Procedure I Cat. 10 516.3/Procedure I, IV |
500.3/Procedure II 501.3/Procedure I, II 502.3/Procedure I, II 503.3/Procedure I 505.3/Procedure I 506.3/Procedure I, II 507.3/Procedure II 509.3/Procedure I 510.3/Procedure I 514.4/Procedure I Cat. 10 516.4/Procedure I, IV |
|
WISCO International, Inc. -
10388 W. STATE RD. 84 #
109 MIAMI, FL 33324-4252. USA Fax: (954) 370-3997 | E-mail: wiscointl@wiscointl.com |
